New Project Antec 1200 Facelift Complete

Hello All, Thats Right im back again. I have been looking for another Project to do, and I still have one on the Drawing Board but I cant see Spending Money on a case thats going to sit around and collect dust, like my Red one that I have. so I thought I would just do a little Modding on my Antec 1200 and give her a Face lift. This is what it looks like at this Time

This Project well take a little more time to do, Plus a Little more of a Challenge for me. So Hang around and see If I pull this Rabbit out of my ass or land Flat on my face Heres a Little Teaser for you all

Whats up all, just a small update had some time so I thought I would Stealth out the Optical Drive

I also line the Second Drive Bay with the glass too, looks pretty good. I need some more acrylic to Finish out the other Bay . Oh the Drive Bay works too

that stealth bay looks pretty clean. i like the looks of it on the case.

Thanks Mass for the reply, Im Glad you like it. Come on guys some feedback from the rest of you would be nice. My Goal here is to post this Build at two other sites after this Build is a little farther along in hopes that it will get pick up by this Sitehttp://www.mnpctech.com/casemodblog/, It would be nice to Headline there site for a Week. So Make A Postal Worker Happy and Post. Ok back to the Build, I mocked up a Power Supply cover for the case today

and Im thinking that I would use Some more of the Black Mirror Glass again to cover it if I can get it to bend for me. Plus covering the Hard Drive Bay marked B, would look nice too. After Thats all installed, there Should be Plenty of room for some Graphics. Well Time for a nap

what are you covering the power supply with?

Im Thinking Mirror Black Acylic and Modding it like this

oh yes. that'll look very sharp...especially with some good cable management

looks good but u should cut out the leters IBA on one side. and put plexy glass behinde the letters with LED lights to make stand out

True it would look nice and heres two Examples of that. One for the side panel, Note the case is also a Antec 1200 the same as mine. http://www.youtube.com/watch?v=0JH9CNpmop0&feature=related .And the other methode is useing plexie glass and there both Good Ideals http://www.youtube.com/user/maxishine#p/u/63/4RajdTJA5wY

I feel like the side panel option would work out the best in your case

Well to tell te Truth, Im going to go in a defferent Direction with this Build, to late to change Direction now.Im going to Mod the Window and focus more on the inside of the case. Those were nice Builds but not for me,

Hello All just an update, I check on what it would cost to do a Window Mod and the Letters using a Water jet , Well it was 150 bucks, so I decided to do some of it myself. Before

Not to bad , I think that well work out just fine. I should be getting the Acrylic Plastic Sheet in Monday , so then I can cover that Power Supply. What do you Guys think dont be shy

what did u cut it out with look good

Black & Decker Jig Saw ,

I still need to clean it up and do a little filing, and add some window trim to it, and a some paint to cover up some scratches and it should be good.